 |
Optospider™:
Fast Ethernet media converter CS-110 for Polymer Optical
Fibers (POF)
DieMount offers four
different types of Fast Ethernet media converters on the basis of Wamin
CS-110 for data transmission via POF. You have the choice between
converters for simplex and duplex POF cables and wavelengths of 650nm
(red) and 470nm (blue). For home networks in appartments and single
family houses a maximum transmission distance of 30m is sufficient for
nearly all situations. These distances can be bridged most convenient
by our Optospider™ CS-110 650nm simplex system. A
corresponding start set with all necessary components to setup a data
link is available.
At the front of the CS-110 media converter there is an array of 8
indicator LED that inform on the media converter status. Internal dip
switches allow the selection of special data transmission modes.
Download: data sheet Fast Ethernet media converter CS-110 |
 |
The Optospider™ CS-110 650nm simplex startset (download short instruction)
consists of 2 media converters including power supply units, 30m
POF
(white, black, transparent jacket or bare fiber), a cutting tool to
reduce the POF cable length and an installation instruction (download installation instruction). |
 |
Optospider™
Fast Ethernet Medienkonverter DMMC for Polymer Optical
Fibers (POF)
The new developed family of POF media converters Optospider™ DMMC is especially designed for home networks and private use.
Power supply is realized via the network cable (passive PoE). No
separate power supply unit is necessary. A special network cable
included to every DMMC media converter uses the 5V power supply as
available at the USB port of the terminal equipment (PC) and injects it
via the network cable to the media converter. In parallel the cable
transmits the data, too. This power supply concept allows to abandon
the bothersome power supply units. As the media converter power supply
is taken from the USB port, the media converter is automatically
switched off, if the terminal equipment is switched off. In this way
the DMMC media converter contributes to energy savings and climate
protection.
The DMMC media converter housing is made of silver
anodised aluminium. For data transmission control there are 2 LED
inside the RJ-45 jack.
Download: data sheet Fast Ethernet media converter DMMC 650nm simplex. |
|
If in one room 2 or more terminal units shall be connected to the
network, the option of choice may be a combination of a
Optospider™ DMMC media converter and a WLAN access point that
provides his power supply to the media converter via PoE and the
network cable. The combination of both modules requires one power
supply only. The installation of the unit is very easy.
As the WLAN access point has to transmit the data in one room only, its
transmit power can be significantly reduced in comparison with an WLAN
system that has to transmit throught the complete building. The
transmit power reduction in the WLAN access point is feasible with
every browser.
The reduction of transmit power is advantageous due to several reasons:
- there is no, or very little interference with a further WLAN system that might be operating in the neighbouring room,
- non authorized persons that use the WLAN system
without permission do have more technical problems to receive
sufficient signal power, and
- the reduction of radio frequency power as far as possible close to human environment is a positive target in general.
If the WLAN AP/POF media converter combination shall be installed as
inconspicuous as possible, the system can be integrated inside a wall
illumination unit e.g.. Further creative solution are feasible of
course, too.
|
If there are further questions or interest in our products please do not hesitate to contact us.
 To view the documents for download on this page you need the free Adobe Acrobat Reader.
|
